Step 3
1) Connect the wires of Console Pillar(D) and Console Solid tube, please make sure the resistance knob are on level 1, then
see picture3 to connet spinner wires (4 steps, you should put the upper wire on the pothook at first, then pull back the wire
to the circular neck) and connect the other 2 wires correctly as picture 4.
2) sliding the console pillar(d) into console solid tube, tightening tchem by using 4 pcs of m8*16mm screws (5), 4 pcs of spring
washer(17) and 4 pcs of φ8* 19 washers(2) and locking them with l wrench 5*5mm(6).
Step 4
1) Connect the wires of console(e) and console pillar(d). (see picture 5). attach the console(e) to console pillar(d) using 4 pcs
of m5* 10mm screws, locked it with wrench(4). (see picture 6)
2) Set handle mandrel(f) into mandrel solid tube.
Picture 5
Picture 4
Picture 3
Picture 6
