HMS EC71330 00MA, Руководство по установке, Страница: 15 / 26

Hardware Description 13 (24)
4.2.3 Status LED
All Versions
Fig. 8 Status LEDs representation — All
versions
Label Description
BI1 Button BI1 input
Steady green = reset button is being pressed
PWR Power
Steady green = unit is powered on
USR User
Blinking green slowly = Unit is ok
Orange pattern = special attention required
KEY Digital IN 1
See Digital Output & Digital Inputs, p. 21
Green = ON : Signal on Input 1 detected
DI2 Digital IN 2
See Digital Output & Digital Inputs, p. 21
Green = ON : Signal on Input 2 detected
T2M
Talk2M
See Digital Output & Digital Inputs, p. 21
Green = ON : Talk2M VPN connection established
Blinking green = A user is connected to this Ewon Cosy+
through Talk2M ( = active remote connection)
@ Internet
Steady green = Internet is configured on the Ewon Cosy+
4.3 LAN Switch Specifications
4.3.1 Boot Process
After powering on or requesting a reboot of the Ewon Cosy+, a wait is required to get the LAN
switch feature fully operational (approximately 2 to 4sec).
The Cosy+ should not be used as a pure Ethernet switch as very short interruptions of the
switch interface need to be taken into consideration.
The ultimate decision the Cosy+ takes when it can no more run a configuration is to reboot itself. This
aims at restoring the requested communication channels and being consistent with the requested
configuration.
4.3.2 LAN Switch Configuration
At the very first boot or after a reset level 2, the Ethernet ports scheme will be configured as
follows:
• Port #1 : LAN
• Port #2 : LAN
• Port #3 : LAN
• Port #4 : WAN
The Ethernet ports functionality can be configured as wanted except for the port #1 which
always remains in LAN mode.
Ethernet port #1 must be used for maintenance operation (such as update).
Ewon Cosy+ Installation Guide
IG-0031-00 1.0 en-US