HMS BE3600, Инструкция по эксплуатации, Страница: 32 / 66

31
A
：
Power off, loosen the running belt as the method of the belt deviation adjustment, then use a brush to evenly
spread the right amount of silicone oil on the running board, be careful not to apply to ourside of running belt coverage,
and then tighten the running belt.
B
：
Please do not lubricate excessively, more lubricant is not better. Reasonable lubricate can extend the
treadmill life!
Malfunction treadment
Warning: In case of malfunction or damage to the power wire, it must be maintained and replaced by the
professional.
Malfunction Reasons Troubleshooting
1.No data shown after
power on ①
The power wire is not properly pulgged
in
②
Overcurrent protector is disconnected
③
The transformer is not plugged in
properly or is damaged
④
The fuse on the drive is broken
①
Replug the wire
。
②
Reset the overcurrent protector
③
Check or replace transformer
④
Replace the fuse
2.E01: fault in speed sensor ①
Speed sensor is mal or assebmly
problem come out
②
The optocoupler of driver is broken
③
Other peripheral part of controlling IC is
broken
①
Check the assembly position or
replace the speed senso
②
Replace the optocounpler
③
Replace the driver
3.E02: fault of m otor
overcurrent
①
The motor current is excessive
②
The resistance of roller is too high
③
The part of driver is broken
①
Replace the motor
。
②
Strengthen the lubricate or
replace
③
Replcace the driver
4. E03: fault of
communication
①
Signal wire is broken
②
The optocoupler of driver is broken
③ The part of the console is broken
①
Check the joint of signal wire
which connects the console and
driver or replace the wire
②
Replace the driver or the
optocoupler of dirver
③ Replace the board of console
5.E04: fault of driver power ① The motor does not plug in properly, or
the motor is broken (circuit open)
②
The relay or drive of driver is broken
③
The b ridge rectifiers of driver is broken
④ Other peripheral part of controlling IC is
broken
① Check or replace the motor
②
Replace the relay or the driver
③
Replace the bridge rectifieror the
driver
④ Replace the driver
6.‘--’displayed in incline
window: fault in incline
detection
①
The incline sensor does not plug in
properly
②
The incline sensor is broken
③
The part of driver is broken
①
Check connection of the plug
②
Replace the incline motor
③
Replace the driver
7.It runs normally without
load, but it is difficult to start
after load,with pause
①
The torque adjustment of driver is small
②
The running belt is too loose
。
③
There is fault in motor
。
①
Adjust the torque potentiometer
on the drive
②
Adjust the running belt
③
Replace the motor