Intesis
TM
Modbus Server
– Mitsubishi Heavy Industries AC
User’s Manual r1.0 eng
© HMS Industrial Networks S.L.U - All rights reserved
This information is subject to change without notice
URL https://www.intesis.com
18 / 26
Content in this tab is just informative: no information has to be set up.
Figure 4.5
Modbus signal list
1.
Address Formula:
Formula used by Intesis
TM
to define the Modbus address for
the point. Use this address (obtained with this formula) to access the point from
your Modbus master device.
2.
R/W
:
Indicates if the signal is read-only, or if it can be read and written (from the
Modbus system point of view).
3.
Signal:
Signal description.
4.
Values:
Possible values for the signal.
See section 2.5 for further detail on address mapping and the possible values on each
signal.
Sending the configuration to Intesis
TM
When the configuration is finished, follow the next steps.
1.- Click on
Save
button to save the project to the project folder on your hard disk
(more information in LinkBoxMB User Manual).
2.- You will be prompted to generate the configuration file to be sent to the gateway.
a.- If
Yes
is selected, the binary file (MHI.Lbox) containing the configuration
for the gateway will be generated and saved also into the project folder.
b.- If
NO
is selected, remember that the binary file with the project needs to
be generated before the Intesis
TM
starts to work as expected.
3.- Once in the configuration window again, click on
exit
. Configuration file is ready
to be sent to the Intesis
TM
device.
1
2
3
4
