HMS Networks Ewon Cosy 131, Руководство по установке

Страница: 24 / 32

IP Address & Access to the Web Configuration 22 (30)
5 IP Address & Access to the Web Configuration
5.1 Factory Default IP Settings
Characteristics Values
LAN IP address 10.0.0.53
LAN subnet mask 255.255.255.0
Gateway 0.0.0.0
Since firmware version 10, the WAN IP address is set by default in DHCP mode.
5.2 Powering On
Power on the unit and wait approximately 45 seconds until the boot process is completed.
After a successful boot process the USR LED is blinking green slowly.
If the USR LED is blinking red according to a given pattern, it indicates that the boot process was
interrupted due to a problem. The most frequent problem is :
• a duplicate IP address was detected on the LAN network: USR LED blinking pattern is red 1x
short, 1x long
For other error LED patterns, please refer to the General Reference Guide for Cosy 131 from the
Related Documents, p. 3 .
5.3 Connecting to the LAN IP Address
Establish the first communication with the Ewon Cosy 131 by using Ewon Cosy 131 companion
tool
eBuddy which can be downloaded from www.ewon.biz/support .
Connect a LAN port (port #1 is always set as a LAN port) of the Ewon Cosy 131 to one’s computer
either through a point-to-point connection or a network where there is no risk Cosy 131's default
IP address (10.0.0.53) would conflict with another connected device.
5.4 Ewon Cosy 131 Web Interface
While the computer is connected to a LAN port of the Ewon Cosy 131, open an Internet browser
and reach the Ewon Cosy 131 web server whose URL is the LAN IP address of the Cosy 131.
Another way to access the web panel of the Cosy 131 is by using eBuddy. To get started with
eBuddy and access the Cosy 131, refer to the eBuddy of the
Related Documents, p. 3 .
At the very first boot of the Cosy 131 or after a level 2 reset, an interface language selection will
be proposed.
Before beginning the configuration of the Cosy 131, an authentication is required.
Default login & password are both adm .For security reasons, default password must be
modified.
A configuration wizard will be proposed afterwards which sets the configuration of the Ewon
Cosy 131 but also the connection to the Talk2M environment.
On our website, a Quick Start Guide can be found which helps in the configuration of the Ewon
Cosy 131
Ewon Cosy 131 Installation Guide
IG-0022-00 2.8 en-US