background image

 

8

VIII.  EQUIPMENT SPECIFICATIONS 

Battery type:   

3.6 Volt Lithium Ion 

Battery life:   

8 hours (typically) 

RF Frequency: 

Receive     -  457.5125MHz – 457.6125MHz 

 

 

 

Transmit    -  468.4875MHz – 469.8875MHz 

Weight: 

 

4.7 oz (1.33 kg) with battery 

Controls: 

 

Power ON/OFF button 

 

 

 

Volume-up button 

 

 

 

Volume-down button 

 

 

 

“A1” button 

 

 

 

“A2” button 

 

 

 

“B” button 

Indicators:   

Dual color LED (red/green) 

 

IX. 

FCC NOTICE 

HME wireless radio frequency systems are type-accepted in the United States under Part 
90 of the Federal Communications Commission (FCC) Code of Federal Regulations, and 

type-approved in Canada by Industry and Science Canada.  Because licensing depends 
on the system’s application, it is the user’s responsibility to apply for a license from the 
FCC in the U.S. and its possessions, or from Industry and Science Canada in Canada and 

its territories.  Licensing requirements vary from country to country.  Contact your local 
licensing agency for specific requirements. 
This device complies with Part 15 of the FCC rules.  Operation is subject to the following 

two conditions:  (1) This device may not cause harmful interference, and (2) This device 
must accept any interference received, including interference that may cause undesired 
operation. 

NOTE

:  This equipment has been tested and found to comply with the limits for a Class A 

digital device, pursuant to Part 15 of the FCC rules.  These limits are designed to provide 

reasonable protection against harmful interference when the equipment is operated in a 
commercial environment.  This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the instruction manual, 

may cause harmful interference to radio communication.  Operation of this equipment in a 
residential area is likely to cause harmful interference, in which case the user will be 
required to correct the interference at his own expense.

 

Changes or modifications not expressly approved by HM Electronics, Inc. could void the users 
authority to operate this equipment.

 

Содержание HS400









Отзывы: