HME HS400, Руководство по эксплуатации

Страница: 5 / 8

5
IV. AUTO-HANDS-FREE SETTING
The auto-hands-free feature allows only one operator to communicate with a customer in
one drive-thru lane without pressing any buttons.
CAUTION: Only one HS400 per lane can be set in the auto-hands-free mode, or
interference will occur when a customer enters the drive-thru lane.
••
With the power already on
, press and hold
Power
button and touch
Volume-down
button — You will hear “
Auto-hands-free on
” or “
Auto-hands-free off
”
NOTE: You must touch Volume-down button within 2 seconds after pressing the
Power button, or you will turn the power off and have to begin again.
•• The last auto-hands-free on/off message you hear will remain in effect until you change
it again.
V. CONFIGURATION SETTINGS
••
With the power already on , press and hold Power button and press B button.
NOTE: You must press the B button within 2 seconds after pressing the power button,
or you will turn the power off and have to begin again.
••
You will hear “ Configuration ” in headset
••
Select any configuration setting described in A – C, beginning below
•• When finished, press and release B button to exit configuration-settings mode. You
will hear “ Power on, lane (one or two) ” in the headset earpiece
••
Configuration settings will remain in effect until you change them again
A. Hands-free On/Off
••
Touch and release Volume-down button — you will hear “ Hands-free on ”
•• Touch and release Volume-down button again — you will hear “ Hands-free off ”
•• You will continue to hear “ Hands-free on ” or “ Hands-free off ” messages alternating
each time you touch and release Volume-down button. The last hands-free on/off
message heard will be selected when you exit the configuration-settings mode
B. Single/Dual Lane
••
Touch and release A1 button — you will hear “ Single lane ”
••
Touch and release A1 button again — you will hear “ Dual lane ”
••
You will continue to hear “ Single lane ” or “ Dual lane ” messages alternating each
time you touch and release
A1
button. The last single/dual lane message heard
will be selected when you exit the configuration-settings mode