LOOK MA, NO HANDS!
BLUETOOTH
®
CONNECTION – IT’S A SETUP
Like any amazing couple, this one starts with a connection — one between your
device and the earbuds’ Bluetooth. Here’s how it works:
1. Make sure the smartphone, tablet, or computer you’re using with
the earbuds has Bluetooth.
2. If your earbuds do not automatically turn on after removing them from the
charging case, turn on the earbuds by pressing and holding the play/pause
button for 2 seconds (look for the little blinking light). The right earbud will
blink red and blue alternately and the left earbud will blink blue.
3. Do whatever your device needs you to do on that end to turn on Bluetooth.
4. Look for “Jaunt” in your device’s Bluetooth list, or click yes.
5. Now hit play on your earbuds and crank it up — or down if you’re lame.
The device and the Bluetooth will find each other every time as long as
the earbuds are set to Bluetooth and your device’s Bluetooth is, you know, on.
If you’re connecting to a computer, you may have some extra steps on that
end. You’ll have to get that information from the computer company.
Depending on your device, you may be prompted to enter a pairing code. If
prompted, enter “0000” as the code. Your earbuds will automatically enter
pairing mode.
Note: If you turn on your Jaunt earbuds but haven’t started the party yet, they
will automatically power off after 15 minutes of unpaired inactivity.
When friends call to interrupt your party of one — and you know they will —
answer the phone without disconnecting from your Jaunt earbuds. Yes,
that’s right. Your earbuds have hands-free calling, too. How amazing is that?
Here’s how it works:
1. Make sure your phone and earbuds are connected through Bluetooth.
2. Answering and ending a call work the same way: Just click the play/pause
button on your Jaunt.
3. If you’d rather not talk, hold down the play/pause button on your earbuds
for 3 seconds to ignore the call.
THE COOLEST PART: The Jaunt earbuds know when a call is coming in and
will pause the music before ringing. When you hang up, the music starts
where it left off — and so does the party. If it’s you making the call, just start
dialing from your phone, and Jaunt automatically does its hands-free thing.
Isn’t it refreshing to know your earbuds totally get you?
Check out the chart below for a complete guide on handling calls with your Jaunt earbuds.
COMING CLEAN
A soft, dry towel is all you need to clean off your earbuds. Using water, harsh
cleaners, or anything else only messes with the mechanics inside.
TROUBLESHOOTING
1. Turn off Bluetooth on your device.
2. Take earbuds out of your case.
3. Press and hold “play/pause” button for 5 seconds on both
earbuds to turn them off.
4. Press and hold “play/pause” button for 2 seconds on both
earbuds to turn them on.
5. Earbuds should automatically go into sync mode once powered
on. The master (left) earbud LED will flash blue and red
alternately, while the slave (right) earbud LED will slow flash blue.
If they do not automatically go into sync mode, quick-press
“play/pause” button twice on both earbuds to put into sync mode.
6. Turn on Bluetooth.
7. Pair to “HMDX Jaunt”.
2s
>
HMDX Jaunt
Devices
on
Bluetooth
®
15m
Incoming call
Pick up call
Reject call
On call
End call
Move call from earphones to device
Second incoming call
Answer second call, first call on hold
Reject second call
Situation
Short press play/pause button
Long press play/pause button
