HKS DMR-150D, Инструкция по эксплуатации

Страница: 10 / 14

35 36
2) Shock Sensing Mode
When shock/impact is detected over the preset level, the image can be recorded a set time before
and after. This time can be set as either 10 seconds or 15 seconds under "1Channel" setting
("2Channel" is 10 seconds). Default setting: 10 seconds before and after the impact.
3) Emergency Record
When set in Shock Sensing mode, pushing the button on the DMR will allow events before and
after to be recorded. The time of recording is the same as set in Shock Sensing mode.
5.Ejecting the SD Memory Card
The procedure below must be followed when ejecting the SD memory card to view the recorded
images.
3.Reception of GPS Signal
When the GPS signal is received properly, the GPS LED (Blue) on the right side of the main unit
blinks. It may take a few minutes to several minutes.
4.Stop Recording
Stop driving, and shut off the engine. The recorded images are saved in a few second.
The unit beeps 3 times (When beeping sound is set to on.) and ends recording.
Do not eject the SD memory card before turning off the power of the unit. It may damage the
recorded images.
A. Stop the engine, and remove the ignition key.
B. LED comes off after the unit beeps 3 times (when warning beeping sound is set to on)
to complete recording.
C. Eject the SD memory card after all LED are turned off.
When using the Constant Power Supply unit, make sure the power of the main unit and the
Constant Power Supply Unit are off before ejecting the SD memory card to prevent damage to
the recorded images.
When images were recorded while the GPS wave cannot be received, (especially at beginning)
the file name may not reflect the correct recorded date.
DMR Main Unit
Starting-up
After
Starting-up
During reception of
GPS Signal
In Operation
Detection of
Shock/Impact
Optional
Recording
Microphone
ON
Connection Status
Button Input
LED Status
Left
(Power + Operating Condition)
Right
(GPS)
Side
(Microphone)
Beeping
Sound
37 38
◆LED and Beeping Sound Setting
Power is on.
Color Purple Blue
5 beeps
Condition Blink Blink
(Beep sound is set to on.)
Video setting
Color Red Blue
"1Channel"
Condition On Off
Video setting
Color Purple Blue
"2Channel"
Condition On Off
Color Red or Purple Blue
Condition On On
Color Red or Purple Blue
Condition Blink(Every 1.5 sec.) On
Color Red or Purple Blue
Condition Blink(Every 0.3 sec./10 sec.) On
Press Emergency
Color Red or Purple Blue
Record Button once. Condition Blink(Every 0.3 sec./10 sec.)
On
Press Emergency Record
Color Red
Button more than 2 seconds. Condition
On
DMR Main Unit
Microphone
OFF
Firmware
Update
Operation End
SD Memory Card
Status
Starting-up
Viewer Mode
Exit from
Viewer Mode
Connection Status
Button Input
LED Status
Left
(Power + Operating Condition)
Right
(GPS)
Side
(Microphone)
Beeping
Sound
Press Emergency Record
Color Red
Button more than 2 seconds. Condition Off
Power is off.
Color Red or Purple Blue Red
3 beeps
Condition Off Off Off (Beep sound is set to on.)
Not inserted
Color Purple Blue
Beep at
Write protect mode
Condition Blink Blink
certain intervals
SD Memory Card Error
Color Purple Blue
5 beeps
Condition Blink Blink
Color Purple Blue
2 beeps x 2
Condition Blink twice Blink twice
Press Multi Button Color Blue Blue 3 beeps
more than 3 seconds. Condition
On On
(Beep sound is set to on.)
Press Emergency Record
Starting-up DMR main unit begins.
Button under Viewer Mode