3
DIGITAL TEMPERATURE & TIME INSTRUCTIONS
1. Turn on the machine by pushing the on/off switch.
2. To change or set the temperature, press the menu button on the digital
control. The light next to “TEMP” will light. Press the up
s
, or down
t
, button to your desired setting.
3. To change or set the time, press the menu button on the digital control.
The light next to “TIME” will light. Press the up
s
, or down
t
, button
to your desired setting.
4. When you have your desired settings
press the menu button a third
time to lock in your settings
otherwise the previous settings will still
be used.
5. Wait for the machine to reach your preset temperature by monitoring
the display temperature until it matches the set temperature.
Daily cycle is displayed by holding the up key while powering up. It will
continue to display counts (up to 9999) while the up key is pressed.
When the key is released it goes to regular mode.
NOTE:
This machine is programmed from the factory to turn the heat off
after 3 hours of non use.
One Minute before the machine is going into “Auto Shut Down” mode,
the controller will “BEEP” five times to alert the operator that the machine
is about to shut the heat off. If nothing is done, then in one minute, the
display on the controller will show “OFF” and the machine will start to
cool down.
To circumvent from shutting the heat off, or to reactivate the heat from
the “Auto Shut Off” mode, simply lower the handle of the machine to acti-
vate the timer and it will start heating again for another 3 hours.
CHANGE AUTO SHUT OFF TIME SETTING
1. Power “OFF”, press and hold the “Down” button, then power “ON”.
Release the “Down” button. The current Auto Shut Off Time will be
displayed.
OPERATION
AUTO SHUT OFF FEATURE
Pressure
Readout