Hold the remote control
and press the upper
body to slide down.
The body and shell
are separated.
Hold the Shell and
take up the body.
Pull out the battery
and replaced with
new ones.
1. Speaker placement
Put the main speaker on the right and passive
speaker on the left When listening to music, the
distance between the two speakers should be
over 70cm so that a natural sound field can be
achieved. Adjust the angle and distance of the
speakers until optimal sound accuracy and
imaging are achieved.
In order to get best sound, not only do we
recommend using high quality components to
match the speakers, but also a good listening
environment. The placement and the size of the listening area will influence the sound
quality.
2. A few simple suggestions to optimize your listening environment:
a. Carpet the floor to avoid the sound reflection.
b. Decorate the wall with cloth or other sound absorbing materials to improve sound
quality.
c. Use thick curtain to avoid the sound reflection by glass windows.
Remote control introductions
1. After the speakers are connected properly, turn on the power when the indicator light is
red, the speaker is in Standby mode. Press the Standby button, the indicator is green
when the speaker is in working mode and default input is LIN1.
2. Press other button and it can be switched to LIN2, bluetooth, optical or coaxial input and
the indicator will change accordingly.
3. Press MUTE the speaker is in Mute when the indicator is red light flashing then press
again, the speaker is unmute.
4. Long-press the volume up, the volume can go up quickly.
5. Long-press the volume down, the volume can go down quickly.
How to replace the remote's battery
IV. Speaker placement and listening environment
Passive speaker
TV/PC
Avoid Magnets
Do not touch the
drivers with hands
Avoid corrosive
liguids and gases
Do not place in high
heat and humidity
for extended period
of time
1. Problems with sound quality
a. Please check and make sure all drivers have sound or not? Is there any problem with
the speaker?
b. Please check if the connection cables are firmly connected with the OUTPUT of the
computer sound card or OUTPUT of the line output.
c. Please check if the connection cable is inserted to the right position.
2. No sound at all
a. Please check if the power cable is connected well, if the power switch is on.
b. Please check if the signal cable between the speaker and the sound source is short-
circuited?
c. Please check if the sound source is set up properly.
3. Only one speaker has sound
a. Please check the balance controls on the sound source and make sure it is set to the
middle position.
b. Please check the cable between active speaker and passive speaker is inserted
properly.
IX. Trouble shooting
If the problems still exist after you checking as No. IX shows, please contact the local
dealer.
X. Warranty
Содержание M200MKIII+
Страница 1: ... Swan Speakers Inc ...
Страница 2: ......
