HITEC X1 AC Plus, Инструкция по эксплуатации

Страница: 21 / 36

21
The X1 off ers the following NiCd/NiMH charge modes: Charge, Discharge and
Cycle.
BEFORE SELECTING A CHARGE MODE, IT IS CRITICAL THAT YOU
SELECT THE CORRECT TYPE OF BATTERY TO BE CHARGED. FAILURE TO
DO SO CAN RESULT IN DAMAGE TO THE BATTERY.
Selecting the Battery Type
After you power on the X1, press the
■
button repeatedly until you reach the
appropriate progam for the battery type you wish to
charge. For this example we have chosen the “
NiMH
BATT
“ program. Now press the
►
button to enter the
desired program.
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE YOU
HAVE READ AND UNDERSTAND ALL OF THE WARNINGS AND SEFETY
INFORMATION CONTAINED ON PAGES XX-XX.
After selecting the correct battery type, if the screen does not read “
CHARGE
”,
use the
✚
or
▬
buttons to change it to the “
CHARGE
“ mode.
Press the
►
button and the amp rate value will begin
fl ashing. Use the
✚
or
▬
buttons to adjust the value
to the desired rate. Follow the instructions provided with your battery when
setting the amp rate.
The charge rate can be set to “
Aut
“ (automatic) or
“
Man
“ (manual). If you choose“
Man
“, the charge rate
will remain the same throughout the entire charge
cycle. If you choose “
Aut
“, the X1 will determine the
appropriate charge rate. In the “
Aut
“ function you should set the upper limit
of the charge current to avoid damage by an excessive charge rate. To choose
between the “
Aut
and
Man
“ function, press and hold the
✚
and
▬
buttons
simultaneously while the amp rate is fl ashing. Release both buttons once the
screen displays the desired setting.
NiCd/NiMH
NiMH CHARGE Aut
CURRENT 1.6A
NiMH CHARGE Aut
CUR LIMIT 1.6A
NiMH CHARGE Aut
CUR LIMIT 1.6A
NiMH CHARGE Man
CUR LIMIT 1.6A
This program is only suitable for charging/discharging NiCD/NiMH batteries.
Charge Modes
NiCD/NiMH
Charge Mode
PROGRAM SELECT
NiMH BATT
Warning
Warning