1-6
StarBoard FX-77/FX-63/FX-82W
Introduction
English
(2) Board Installation
Install the board on the stand assembled in step (1). Install the board according to the
following procedure. Furthermore, this step should be performed by at least two
people. Numbers in the diagram correspond to numbers in the parts list on page 1-2.
(a) Decide the level (out of six) at
which the board will be installed,
and use the square holes on the
back of the board to hang it on the
board receiving brackets.
(b) Verify that one of the board’s
square holes is attached securely to
the board receiving bracket on each
side.
(c) Tighten triangular knob screw to
fasten the board to the board fixing
bracket on each side.
(6)
(4)(5)
(10)
Board
This work should be performed by at least two people.
The board might fall and cause injury or its impact might cause damage.
Fasten the screws tightly.
The board might fall and cause injury or its impact might cause damage.
CAUTION
