Hitachi WR 16SA S, Технические данные и руководство по обслуживанию

Страница: 6 / 29

--- 3 ---
(3) Higher durability thanks to the metallic bearing bushing
A metallic bearing bushing is built in and the outside is covered with resin tail cover for higher durability. The
resin tail cover secures the bearing bushing and also prevents the CB cap from loosening.
Bearing bushing (metal)
(4) Slip-resistant and comfortable soft grip handle
The grip of the Model WR 16SA is soft, slip-resistant and comfortable thanks to the soft material (elastomer
resin) covered on the handle. The Model WR 16SA gives minimum fatigue to the operator's hand even if it is
operated for a long time.
(5) Housing is covered with elastomer entirely
The Model WR 16SA gives no scratch on the floor etc. where it is placed because the housing is covered with
elastomer entirely. In addition, the elastomer-covered housing prevents the Model WR 16SA from slipping on
a slanted surface such as a roof.
(6) Large bumper protects the outside
Prevention of damaging workpieces and being stained
The Model WR 16SA minimizes damaging workpieces even if it contacts the workpiece.
The hammer case is not hot when touched during continuous operation.
The hammer case is covered with a large bumper. Because the bumper is resistant to transmitting heat, the
bumper is not hot even if held by hand during operation.
(7) Grip end is shaped like a finger stopper for portability
The grip end is thickened to make it as a finger stopper for portability.
CB cap
Tail cover (resin)