Hitachi WH 18DBDL, Инструкции по безопасности и руководство пользователя

Страница: 15 / 68

English
15
Fig. 13
(1) High/Low selector switch
The rotation speed changes in 4 steps (900 1,400
2,000 2,600/min) each time the high/low selector
switch is pressed.
(2) Single/Continuous selector switch
The tightening torque can be adjusted according to
the work by changing the tightening mode using the
single/continuous selector switch and the high/low
selector switch on the side of the impact driver/
wrench.
When the forward/reverse button is set to reverse,
the high/low mode and single/continuous mode are
set to “High” and “Continuous” respectively,
regardless of the indicators on the switch panel.
The mode switches between single and continuous
mode each time the single/continuous selector
switch is pressed.
In single mode, after the trigger switch has been
pulled to start operation, bolt-tightening stops
automatically after 1 to 4 tightenings.
In continuous mode, when the trigger switch is
pulled to start operation, bolt-tightening continues
(without stopping automatically).
NOTE:
䡬
The appropriate mode differs depending on the
screw and the material being screwed. Drive in a
few test screws and adjust the mode setting
accordingly.
䡬
The high/low and single/continuous selector
switches can only be set after the battery has been
installed in the impact driver/wrench and the trigger
switch has been pulled once.
NOTE:
䡬
Do not give a strong shock to the switch panel or
break it.It may lead to a trouble.
䡬
To save the battery power consumption, the
remaining battery indicator lamp lights while
pressing the remaining battery indicator switch.
11. How to use the LED light
Every time you press the light switch on the switch
panel, the LED light lights or goes off. (Fig. 12)
To prevent the battery power consumption, turn off
the LED light frequently.
Fig. 12
CAUTION
Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
NOTE:
To prevent the battery power consumption caused
by forgetting to turn off the LED light, the light goes
off automatically in about 15 minutes.
12. Tightening mode selector function (Fig. 13)
CAUTION
䢇
Do not subject the switch panel to shock or
damage.
䢇
Select high/low mode and single/continuous
mode while the trigger switch is released. Failure
to do so could result in malfunction.
Light switch
Single/
Continuous
selector
switch
High/Low
selector
switch
Single/
Continuous
indicator lamp High/Low
indicator
lamp
01Eng_WH18DBDL_US.p65 8/28/13, 13:42 15