--- 9 ---
7. PRECAUTIONS IN SALES PROMOTION
In the interest of promoting the safest and most efficient use of the Models W 6VM, W 6V4 and W 6VA4 electric
screwdrivers by all of our customers, it is very important that at the time of sales the salesperson carefully ensures
that the buyer seriously recognizes the importance of the contents of the Handling Instructions, and fully
understands the meaning of the precautions listed on the Caution Plate attached to each tool.
7-1. Handling Instructions
Although every effort is made in each step of design, manufacture and inspection to provide protection against
safety hazards, the dangers inherent in the use of any electric power tool cannot be completely eliminated.
Accordingly, general precautions and suggestions for the use of electric power tools, and specific precautions and
suggestions for the use of the electric screwdriver are listed in the Handling Instructions to enhance the safe and
efficient use of the tool by the customer. Salespersons must be thoroughly familiar with the contents of the
Handling Instructions to be able to offer appropriate guidance to the customer during sales promotion.
7-2. Caution Plates
The following basic safety precautions are listed on the Name Plate attached to the main body of each tool.
However, these precautions are not listed for European countries.
For Asia and Oceania
CAUTION
Read thoroughly HANDLING INSTRUCTIONS before use.
For the U.S.A. and Canada
WARNING
To reduce the risk of injury, user must read and
understand instruction manual
AVERTISSEMENT
Afin de reduire le risque de blessures, l'utilisateur doit
lire et bien comprendre le mode d'emloi.
7-3. Screw Driving-depth Adjustment
Information and suggestions for screw driving-depth selection for applicable screws are described in the Handling
Instructions. The salesperson must be thoroughly familiar with screw driving-depth adjustment procedures to be
able to instruct the customer/user in performing adjustment so that the screw neither protrudes above nor sinks
excessively below the surface of the workpiece into which the screw is driven.
