--- 19 ---
Fig. 31
Narrow angle
Clockwise
Wide angle
Counterclockwise
(3) If the line "A" on the cam cover is out of the range of the angle gauge mark, finely adjust the bending accuracy
as follows (Fig. 31).
(a) Unplug the power cord from the receptacle.
(b) Remove the tail cover.
(c) Take out the printed circuit board for adjustment and slightly turn the fine adjustment volume clockwise if
the bending angle is narrow and counterclockwise if the bending angle is wide.
(d) Plug the power cord in the receptacle and check the accuracy again with an angle gauge. Repeat the
adjustment until the line "A" on the cam cover is within the range of the angle gauge mark.
Fine adjustment volume
Содержание VB 16Y
Страница 29: ......
