Hitachi V-209, Руководство по эксплуатации

Страница: 21 / 47

Then connect the battery pack connector to the
connector of the oscilloscope.
d) Mount the plate with screws.
e) Fix the upper enclosure on the oscilloscope with
four screws.
Fig. a
Fig. b
<CAUTION>
Upper enclosure
Bauery
Ba ucry pack
Battery pack fi,ing
�crew
AD-209
When mounting the battery pack AD-209, take care not
to damage the connecting cables and components.
6. HOW TO PRODUCE THE BRIGHT LINE
Before turning 0 the POWER switch. insure the power
supply voltage is within the range of 90 - J30V for AC IOOV
set. 180 260V for AC 200V set.
Insert the plug of the power cord on the rear panel into the
power supply wall socket and set the controls as follows.
POWER
OFF
IN TEN
Counterclockwise to the full
FOCUS
M1drange
AC-GND-DC GND
�I POSITION Midrange {the knob is left
depressed )
V. MODE
(Ill
TRIG
AUTO
TRIG SOURCE CHI
TIME/DIY
0.5 ms/div
::: POSITION
Midrange
Set all the levers of the switches to the upper side.
After ending all the setting mentioned above. turn 0 the
POWER and. 15 second later, rotate the INTEN knob clock­
wise. Then the sweep bright line will appear. If the observation
is to be started immediately. set the
FOCUS control at a point
where the bright line is sharpest.
17