SINELINK24G
11
2-3 Preparation for installation.
(1) Confirm the fit of mounting bracket
1
Confirm the fit of the
mounting bracket.
There are markings of V
and H on the back of
the Antenna. If you set
the V upward (factory
default), then vertically
polarized wave is
selected. Likewise,
horizontally polarized
wave is chosen by
setting the H upward.
Polarization of the wave
must be the same with
the opposite product.
Unless, transmission
can not be established.
On the following cases,
set the marking H
upward.
* When you can see
opposite product
through the scope only
when setting H upward
due to obstacles.
* No availability of
channel in vertical
polarization.
* To avoid interference
from the other pair of
this products nearby.
To set the H upward,
remove the four M6
bolts on the rear, then
rotate the mounting kit
90 degrees
counterclockwise.
Finally fasten the four
M6 bolts to a torque
range of 5.59 to
6.66[N/m]. (57 to
68[kgf/cm])
The same marking, H or V, has to be set upward
between a pair of this products.
M6 bolt x4
“H”
“V”