– 24 –
AFTER SALE SERVICE AND WARRANTY
WHEN ASKING FOR SERVICE, CHECK THE FOLLOWING POINTS
When it does not operate
●
Is the fuse all right?
●
Is the voltage extremely high or low?
●
Is the circuit breaker “ON”?
●
Was the air
fi
lter cleaned?
●
Does sunlight fall directly on the outdoor unit?
●
Is the air
fl
ow of the outdoor unit obstructed?
●
Are the doors or windows opened, or is there any source
of heat in the room?
●
Is the set temperature suitable?
CONDITION
CHECK THE FOLLOWING POINTS
Notes
●
In quiet operation or stopping the operation, the following phenomena
may occassionally occur, but they are not abnormal for the operation.
(1) Slight
fl
owing noise of refrigerant in the refrigerating cycle.
(2) Slight rubbing noise from the fan casing which is cooled and then
gradually warmed as operation stops.
●
The odor will possibly be emitted from the room air conditioner because
the various odor, emitted by smoke, foodstuffs, cosmetics and so on,
sticks to it. So the air
fi
lter and the evaporator regularly must be cleaned
to reduce the odor.
●
Please contact your sales agent immediately if the air conditioner still fails to operate normally after the above
inspections. Inform your agent of the model of your unit, production number, date of installation. Please also
inform him regarding the fault.
●
Power supply shall be connected at the rated voltage, otherwise the unit will be broken or could not reach
the speci
fi
ed capacity.
When it does not cool well
When it does not hot well
Please note:
On switching on the equipment, particularly when the room light is dimmed, a slight brightness
fl
uctuation
may occur. This is of no consequence.
The conditions of the local Power Supply Companies are to be observed.
Minimum Maximum Minimum Maximum
Indoor
Dry bulb °C
21
32
20
27
Wet bulb °C
15
23
12
19
Outdoor
Dry bulb °C
21
43
2
21
Wet bulb °C
15
26
1
15
Note
●
Avoid to use the room air conditioner for cooling operation when the outside temperature is below
21°C (70°F).
The recommended maximum and minimum operating temperatures of the hot and cold sides
should be as below:
Cooling
Heating
RAS-18KH(T1)-24GH4 (3).indd 24
RAS-18KH(T1)-24GH4 (3).indd 24
5/12/10 10:25 AM
5/12/10 10:25 AM