Please arrange it as shown below
●
The floor should be sturdy and flat.
Lay a board with 1cm thickness on the floor if the
refrigerator is installed on the carpet, tatami mat,
flooring or PVC sheet flooring which may be hollow
or discolor.
●
Place the refrigerator away from direct sunlight
and heat.
This will reduce adverse effects to refrigerating
power and keep electricity cost down.
●
Do not place it in damp areas, and ensure good air
ventilation.
This will prevent the refrigerator from rusting and
dew condensation.
●
The place should be separated from other equipment.
To prevent disturbance (noise / scattered image)
to TV and others attributable to the refrigerator.
●
Always wipe the adjustable mounts and floor clean before
placing pads. Adherents may scratch the floor if they remain.
The height of the door can be adjusted 1mm every one turn of the adjustable mount.
Clamp the supplied tool adjusting to the shape of the adjustable mounts.
Turn the left Adjustable mount to
lower the left side door.
Turn the right Adjustable mount to
lower the right side door.
Cushion (Accessory)
Fixing the refrigerator on the level or adjusting its horizontal level
BEFORE USE
Preparation before use
To remove leg covers, hold the both ends of one leg cover and
pull it towards to you and repeat this operation for another leg
cover.
Place pads under the adjustable mounts.
Place pads under the adjustable mounts evenly so that they can be leveled.
Rotate the right and left adjustable mounts until they reach the floor.
Adjust the mounts so that the right and left doors of the Refrigerator
Compartment get parallel.
Insert the fork of the leg cover into
the mounting holes to attach the
cover.
Make sure to use a supplied tool and
2 cushions
●
Be careful not to scratch the floor with the supplied tool when turning the
adjustable mount.
●
Excessively turning an adjustable mount may cause it to detach.
Adjustable mounts
Leg cover
Supplied tool (Accessory)
Supplied tool (Accessory)
Supplied tool
Cushion
■
The left side door is lower.
■
The right side door is lower.
1
2
1
2
3
4
●
Depending on the material or strength of a
floor on which the refrigerator is installed or
the weight of food put in it, a door may sag
in several days (about five days) after the
installation.
If this happens, adjust the parallelism between
the doors again.
●
Installing the refrigerator on an unlevel floor or
sinking of its leg(s) due to a floor which is not
strong enough to support the weight of food
may cause a difference in level between the
right and left doors.
This does not affect the refrigerator function.
Adjust the parallelism of the doors according to
the left procedure if you want to correct it.
●
Correcting any left/right lean and lifting slightly
the front side of the refrigerator until the door
can close easily and completely.
●
When you release your hand from a refrigerator
door with the door open, the door may move,
but this is normal.
Notice
●
Provide a heat-releasing space (See
the right diagram)
※
The actual size of the center part
of the side of the refrigerator’s
main body is slightly larger than the
nominal size. Therefore, please allow
enough space around when installing
the refrigerator.
※
If you care about discoloration of or
dirt on the rear wall, provide a gap
of
2 cm or more
. This also prevents
vibration noise or dew condensation
on the rear wall due to high humidity.
Required space for right and
left of the refrigerator: 1 cm or more
Required space above the
refrigerator: 5cm or more
Mounting hole
Fork
Leg cover
46
