Hitachi R-MX800GVGV0, Инструкция по эксплуатации

Страница: 29 / 64

29
Water from the
Water Dispenser
is not chilled.
● Has the water just been put into the Water Tank ? ● It may take 24 hours or even more to chill the water in
the Water Tank completely ,if the ambient temperature is high
in the summer seasons, etc.. However, it will just take 8 to
9 hours to chill the tank-full of water.
● If you need chilled water immediately, it is effective to put
ice cubes into the glass by using the Ice Dispenser and then
to use the Water Dispenser.
● When using the Water Dispenser, the water dispensed
in the beginning is not chilled enough.
● Chilled water is supplied from the WaterTank in
the refrigerator compartment through the tubes which is
placed in the compressor compartment, the bottom of
the cabinet, and the door. Therefore, the water in
the beginning may not be chilled ,because that water was
not in the cold sections, however, after dispensing half of
glass of water, chilled water will be dispensed.
Water is not
dispensed.
● Is the “Child Lock” lamp on ? ● Reset the “Child Lock” function.
● Is the water in the Water Tank frozen ? ● If frozen, set the temperature of the refrigerator compartment
to level 1 or 2.
● Is the “Cubes”or“Crushed”lamp is on ? ● Touch the “Water” button to select dispensing water.
● Is the “Tank Empty” lamp on ? ● Fill up the Water Tank with water to the "Full" line.
● If there is water in the Water Tank, surely push the Water Tank
into the “Tank Position”.
● Has the Water Dispenser been used for more than
1 minute continuously ?
● If the Water Dispenser is used for approx. 1 minute, the system
temporarily stop dispensing for the sake of safety in case of
a malfunction of dispenserswitch. The “Dispenser Illumination”
flashes to inform you of this case. To use again, release
the glass from the Dispenser Lever.
19
10
17
8
-
-
-
Ice Dispenser and Water Dispenser
Problem Point to be checked Detailed Check Points and Countermeasures Page
-
-
23
23
23
・・・
Problem Point to be check Detailed Check Point and Countermeasure Page
In case of occurred these event,
vacuum compartment might not
be operate.
●
Is the Handle up?
●
Push Handle down to the proper position.
●
Has the Handle been pushed
down to the end Gasket?
●
If not, there is no vacuum. Push the Vacuum Box Case
inside to the end and push the handle down to the proper
position.
●
Are Vacuum Box Gasket and
Packing receiver dirty?
●
If they are, clean them by wiping the stain out.
●
Is Vacuum Box Gasket or
vacuum valve (blue) detached or loose.?
Vacuum valve
(blue)
●
Deliberately attach Vacuum Box Gasket
and Vacuum valve.
●
Is there any bag that contains food or
stain or debris or trash in or around
Vacuum Box Gasket and Packing receiver?
Thread
Trash
Is the gaskets adhered together,gently
stretch it part before using the vacuum
compartment?
Gasket
●
If there is any plastic bag that contains
things inside, remove it. If the packings
are attached to each other, the vacuum
property will be lost.
●
If the sides of gasket stick to each other,
put them apart. If gasket is dirty, clean it.
Vacuum compartment
Troubleshooting