45
Place a sheet or cloth
for protection first, and
then lay it back to drain
water.
Take out foods or ice.
Remove the leg covers, and raise the
adjustable mounts.
Empty the water from the water
supply container/ice tray.
Use a tape to secure the door/power
cord.
See “Preparation before use” for
installing the refrigerator in a new
location.
Pg.44
Pull off the power plug.
No problem just before moving.
Place a sheet or cloth for protection
when moving / transporting it.
To prevent damage to the floor material or water from spilling out.
Make sure to hold the
handles when carrying it
with 2 persons or more.
Do not lay it down horizontally for
transportation (which may cause
failure of the refrigerator).
On the Power Plug.
It is not a problem to plug in the power cord soon after installing the refrigerator.
Use a wall outlet exclusively when connecting the power cord. (Alternating current 220 - 240V, rated 10A or more)
●
Check that the power plug or the cord is not wedged between the back of the refrigerator and the wall in order to prevent the cord from getting hot.
Transporting your refrigerator (transport for moving)
1
4
2
5
9
3
6
7
8
5
Required space above the
refrigerator: 5cm or more
Cooling inside the refrigerator starts.
●
It may take more than 4 hours
to cool well the inside of the refrigerator, depending on conditions such as the ambient
temperature or storage state of foods. It may
take 24 hours or more in summer, etc.
Do not put ice cream, uncooled foods or perishable foods in it until the inside of the refrigerator is cooled well.
●
Perform “Ice Maker Cleaning” when using the automatic ice making function for the first time.
Pg.60
●
A series of ice making operation will start automatically after the inside of the refrigerator is cooled well.
(When using for the first time, it may
take 24 hours and more to make ice
.)
Such as old cloth
Before Use
PLATINUM
Mounting the Platinum Catalyst Case
●
Peel off the tape that fixes the Platinum Catalyst Case in place.
●
Remove the Vacuum Case.
●
Place the Platinum Catalyst Case in the dent on the bottom with “PLATINUM”
facing upward.
●
Replace the Vacuum Case that has been removed.
●
Do not disassemble or wash the Platinum Catalyst Case with water.
●
Placing the Platinum Catalyst Case with “PLATINUM” facing
downward prevents the Vacuum Case from being closed.
●
If you wish to install the refrigerator in a hot spring area exposed to sulfide gas, you may need to apply anti-rust
treatment to the piping. Contact your dealer in advance. Failure caused by sulfide gas will not be covered under
guarantee.
●
After inserting the power plug into a wall outlet, you will hear noise from the refrigerator, which is preparing for
operation. You may also hear a louder noise from the compressor or fan until the inside is cooled down enough.
●
It may give off a smell of plastics in the beginning when you start to use. Keep the room well-
ventilated. Such smell will disappear gradually.
●
Do not peel off the seal on the back or plastics at the lower part of the side.
●
When a magnet or suction cup is attached on the side of the body or the surface of a door, it may
leave a mark.
●
When you attach a paper sheet on the door surface in a high ambient temperature, dew may
form on the door surface, or the paper may absorb moisture.
Notice
Stickers
Plastic parts - Left/Right
4
Platinum Catalyst Case
Caution
Platinum Catalyst Case
Aluminum tray
Vacuum Case
Dent on the bottom