Hitachi Performa CP-RS55, Руководство пользователя и краткое руководство

Страница: 79 / 100

6
Connecting power supply / Putting batteries
Connecting power supply Connecting power supply
WARNING ►Please use extra caution when connecting the power cord as
incorrect or faulty connections may result in fi re and/or electrical shock.
• Only use the power cord that came with the projector. If it is damaged, contact
your dealer to newly get correct one.
• Only plug the power cord into an outlet rated for use with the power cord's
specifi ed voltage range.
• Never modify the power cord. Never attempt to defeat the ground connection
of the three-pronged plug.
1. Connect the connector of the power
cord to the AC inlet of the projector.
2.
Firmly plug the power cord's plug
into the outlet.
Putting batteries Putting batteries
WARNING ►Always handle the batteries with care and use them only as
directed. Improper use may result in battery explosion, cracking or leakage, which
could result in fi re, injury and/or pollution of the surrounding environment.
• Be sure to use only the batteries specifi ed. Do not use batteries of different
types at the same time. Do not mix a new battery with used one.
• Make sure the plus and minus terminals are correctly aligned when loading a battery.
• Keep a battery away from children and pets.
• Do not recharge, short circuit, solder or disassemble a battery.
• Do not allow a battery in a fi re or water. Keep batteries in a dark, cool and dry place.
• Do not give the battery a physical impact.
• If you observe a leakage of a battery, wipe out the fl ower and then replace a
battery. If the fl ower adheres your body or clothes, rinse well with water immediately.
• Obey the local laws on disposing a battery.
1. Remove the battery cover.
Slide back and remove the battery cover in the direction of
the arrow.
2. Take old batteries out and/or put new batteries in.
When putting in batteries, align and insert the two AA batteries
according to their plus and minus terminals as indicated in the
remote control.
3.
Close the battery cover.
Replace the battery cover in the direction of the arrow and
snap it back into place.
AC inlet
Connector of the power cord
Power switch