7
INSTALLATION OF OPTIONAL AIR PANEL: P-G23WA2
9
CAUTION:
-
If tighten long screws insufficient, may cause
something wrong as below.
-
If any gap has even though tighten long screws
sufficient, readjust the height of indoor unit.
-
It’s able to adjust the indoor unit height by using
wrench from the corner pocket.
-
Too considerable adjustment of height cause dewing
from drain-pain.
-
Do not turn the air louver by hand. If moved, the
louver mechanism would be damaged.
NOTE:
In case that the corner pocket is dismantled agter
installing the air panel:
1.
”1” The corner position of the corner pocket ca be
lifted by inserting a ”- ” shaped driver and lifting.
By keeping this state, lift the ”-” shaped driver in
the lower direction. The whole corner pocket can
be lifted. After disconnecting the fixing nails (3
positions), disconnect the L-shaped nail and
remove the corner poc1ket cover.
2.
Slide the cover in the allowed direction.
7.3.
WIRING CONNECTION FOR AIR PANEL
1. The following connector is used with the air panel (view
from lower surface of air panel without air intake grille)
2. Connect the connectors as shown below (view of the
electrical box)
7.4.
TEST RUN
After completing the installation of the air panel, a test run
should be performed by refering to I&O PMML0101A.
Air Leakage
Smudge
Dewing
No gap shall exist
Electrical Control
Box
Connector for Auto
Swing Motor
(Low Voltage,
7Pin, Red)
Electrical Control Box for Indoor
Unit
PCB
Connector for Auto Swing Motor
(Low Voltage, 7Pin, Red)
CN17
Wrench
Coin or Slotted Screwdriver
Corner Position
Lifting
Louver