--- 25 ---
Pull out.
Toward the magazine
Hinge Pin [76]
Cover Spring [72]
Flat-blade
screwdriver
Magazine Ass'y [77]
Fig. 17
11. INSPECTION AND CONFIRMATION AFTER REASSEMBLY
Check that Plunger (B) [60] and Trigger Plunger [66] move smoothly.
Check that there is no air leakage from each part.
While driving staples with an air pressure of 4.5 kgf/cm
2
(63 psi), check that there is no idle driving and
bending of staples.
Note: Before conducting the driving test, turn the Adjuster [52] to the deepest position.
Recheck the tightening torque of each screw.
Check that Pushing Lever (A) [54] and Pushing Lever [51] slides smoothly.
Check that the machine will not operate only by actuating Trigger [67]. Also check that the machine will not
operate only by depressing Pushing Lever (A) [54].
Magazine Cover [70]
Mount the Cover Spring [72] facing the
longer arm side toward the magazine.
(b) Reassembly
Disassembly procedures should be followed in the reverse order. Note the following points.
Apply grease on the sliding portions of the Pushing Lever [51], Sleeve [37] and Nose [26].
Insert the pointed end of the Hinge Pin [76].
Mount the Cover Spring [72] facing the longer arm side toward the Magazine Ass'y [77] as shown in Fig. 17.
Содержание N 5024A
Страница 18: ... 15 9 2 Possible Causes and Correction of Air Leakage Air leakage repair location ...
Страница 34: ......
