Hitachi KP-F145WCL, Руководство по эксплуатации

Страница: 14 / 37

6
Ex.1 Exposure time = setting value XYY
16
to obtain 1/125 second (= 8000μsecond).
16
16
16
16
1 2
2C7 XYY
C7
9
100
7
9
100
1
10
8000
YY
2
1 8000 X
int
int
log int
Ex.2 Setting value 25D
16
that produces 1/234.22 second exposure time.
[sec]
sec] [
) (
234.22
1
4269.53
9
100
5D
1 10
16
16
2 1
ed ShutterSpe
(4) DATA BIT : Setting of output bit depth
8bit (Factory setting) : Image is outputted by 8 bit.
10bit : Image is outputted by 10 bit.
12bit : Image is outputted by 12 bit.
(5) VD/FVAL : Setting of vertical sync signal
VD : Output VD.
FVAL (Factory setting) : Output FVAL.
(6) HD/LVAL : Setting of horizontal sync signal
HD : Output HD.
LVAL (Factory setting) : Output LVAL.
(7) GAIN : Setting of electrical sensitivity
0 (Factory setting) to 18dB : Set from 0 to 18dB in 504 steps.
(8) BLACK LEVEL : Adjust offset level
0 (Factory setting) to 63 : Set in 64 steps.
(9) VERTICAL 2 PIXEL ADDITION : Setting of vertical two pixel addition
OFF (Factory setting) : Not perform vertical two pixel addition.
ON : Perform vertical two pixels addition and frame rate is increased about 2 times.
(10) PARTIAL SCAN : Setting about partial scan
-MODE- : Select of mode
OFF (Factory setting)
: Not perform partial scan.
ON : Perform partial scan.
-START- : Start position of partial scan
1 (Factory setting) to 1040: Scan is started from the line set up in 1 to 1040.
-WIDTH- : Width of partial scan
1 to 1040 (Factory setting): Scan is performed number of line set up in 1 to 1040 is scanned.
* When using partial scan, please make sum total of START and WIDH into 1041 or less.
* When using partial scan, please use FVAL.