Hitachi HV-D27, Руководство по эксплуатации

Страница: 33 / 55

15
13
）
INITIALIZE:
Mask settings are initialized to factory values for each application file. Simultaneously
press the L and R buttons for about 2 seconds to return the selected files to the factory settings. See
Page 25 for the factory settings of each application file.
11
．
OUTPUT/SYNC
On this menu screen, you can make signal changeover for output to the D-SUB connector and phase
adjustment for external synchronization.
１）
OUTPUT
：
Output mode changeover
・
R, G, B
：
The R, G and B video signals are output to the D-SUB connector.
・
Y, R-Y, B-Y
：
The Y, R-Y and B-Y signals are output to the D-SUB connector.
・
Y/C
：
The Y/C signal is output to the D-SUB connector. It can be delivered simultaneously with the
Y/C signal output from the Y/C connector (S terminal).
２ ）
MONO
：
Monochrome (black and white) ON/OFF for the video output signal from the VIDEO
connector
Set to ON for monochrome. Setting ineffective during color bar.
３）
SYNC ON G
：
G video signal synchronization ON/OFF (In the R/G/B mode only)
When output is RGB with Sync on and G on, Sync is added to the G video signal.
４）
GL IN
：
Impedance changeover of input to the GL IN connector.
・
HIGH
：
The high impedance level is provided.
・
75
Ω：
An impedance of 75 ohms is provided.
(Note) When power to the camera is turned off, the high impedance level is provided. So,
do not use this function in a system where power is turned off for the camera unit
only.
５）
GL MODE
：
・
VBS
：
The VBS signal or BBS (black burst) signal is input as an external synchronizing signal.
・
HD/VD
：
The HD/VD signal is input as an external synchronizing signal.
(Note) During external sync with HD and VD signals, be sure to use either RGB or Y, B-Y, R-Y
output signals. Although VBS and Y/C output signals are also produced, these cannot
be used as normal output signals.
R,G,B
Y,R‑Y,B‑Y Y/C
L LL L R
RR
R