Hitachi Gigabit Router GR2000-B Series Quick Start Guide
3-4
GR2K-GA-0008
Rev. 1.00
3.3.3
Open the Configuration File
3.3.4
Set an IP Address for the Ethernet Port
3.3.5
Set a Default Route
*
Note: his is the example for the case where the operative configuration file in memory
is opened. You can open any designated prepared configuration file by inputting
the file name.
FRQILJ
RSHQ
FRQILJ
The configuration file is opened by the
open
command.
The operative configuration file in memory is opened
in case that the file name was omitted.
FRQILJ
OLQH/$1HWKHUQHW
FRQILJ
OLQH/$1HWKHUQHW
FRQILJ
LS/$1
FRQILJ
LS/$1
Set built-in Ethernet Port 0 of as “LAN0” with the
line
command. The "2/0" means that the NIF number is "2"
and the port number is "0" (the built-in Ethernet is com-
mensurate with the NIF number "2”).
Likewise, set built-in Ethernet port 1 as "LAN1." The
prompt
!
is shown after the configuration changes.
Set an IP address and the subnet mask length for
"LAN0" with the
ip
command. For this example, the IP
address is "192.168.1.1" and the subnet mask length is
"24."
Likewise, set the IP address to "192.168.2.1" and the
subnet mask length to "24" for "LAN1."
FRQILJ
VWDWLFGHIDXOWJDWHZD\
A static route is set using the
static
com-
mand. In this example, the address
"192.168.2.2" is set as a default route.
