Hitachi EUP-V73W, Инструкция по эксплуатации

Страница: 27 / 39

‐ 21 ‐ Q1E ‐ EP1430
5.4 Drying
1) Wipe the probe with a single ‐ use, fluff ‐ free wipe or towel to remove moisture from the
surface of the probe.
2) Dry the probe naturally in an ambient temperature between 15 ‐ 30
°
C for a minimum
of 4 hours. Alternatively the equipment can be dried using a drying heater at a
temperature of less than 55
°
C.
5.5 Inspection
Inspect the equipment for any damage such as crack, scratch or deformation. Do not use it
if any damage is found.
5.6 Packaging
Pack the probe in a sterile barrier such as Polypropylene fleece or
transparent package made from Polyethylene film and Tyvek
®
, and then
place it into a tray. The tray should be also covered with a sterile barrier.
Additionally the probe can be placed on plastic mesh wires supplied for plasma
sterilization and then packed as mentioned above.
The probe can be packed in a simple or double packing.
Please note that the size of a sterile barrier should be large enough to be able to pack the
equipment leaving sufficient space to seal it completely.
A sterile barrier should be sealed by an appropriate sealing machine and it is important to
confirm that the package is sealed completely. If the sealing is not complete, pack and
reseal again.
Drying
Packaging