11
English
6. After the engine started, return the choke lever
gradually to “OPEN” position.
7. Warm up the engine without a load for a few minutes.
NOTE: Do not allow the starter handle to snap back. Return it slowly by hand.
NOTE: If the oil level in the engine is low, the engine will not start. If the engine does not start, check the
oil level and add oil as needed.
NOTE: To ensure maximum oil lubrication, place the generator on a level surface.
Fig. 18
Fig. 19
USING ELECTRIC POWER
1. Turn off the switch(es) of the electrical appliance(s) before connecting to the
generator.
2. Insert the plug(s) of the electrical appliance(s) into the receptacle.
●
Check the amperage of the receptacles used referring to TABLE 1, and
be sure not to take a current exceeding the specified amperage.
●
Be sure that the total wattage of all appliances does not exceed the rated
output of the generator.
3. Turn on the switch(es) of the electrical appliances.
WARNING: Be sure to ground the generator if the connected electrical
equipment is grounded.
NOTE: When the generator is overloaded, the circuit breaker will
automatically activate to protect the generator and stop its output.
Reduce the load to within the specified limits and reset the circuit
breaker. Following this, restart the generator.
Fig. 20
Fig. 21
P
R
ES
S TO R
ES
E
T
SU
PPL. PROT
E24SC
E42SC, E62SC
Fig. 17
Up to 9 ampere
Up to 15 ampere
Up to 15 ampere
Up to 25 ampere
E24SC
MODEL
E42SC
E62SC
TABLE 1
