16
English
USING ELECTRIC POWER
AC APPLICATION
1. Check that the pilot lamp is lit.
2. Turn off the switch(es) of the electrical appliance(s) before connecting to
the generator.
3. Insert the plug of the electric appliance to the AC outlet.
● Be sure that the total wattage of all appliances does not exceed the
rated output of the generator.
CAUTION:
●
Securely insert the plug to avoid poor contact,
disconnection or loose connection.
●
Use plug having a grounding terminal shown in the
figure.
WARNING: Be sure to ground the generator if the connected
electrical equipment is grounded.
4. Turn the electric appliance on.
CAUTION: If the protector has functioned to shut off during operation
of the generator, check the following items and, after
removing the cause of the trouble, turn the knob ON again.
●
Check the connected appliances for any fault.
●
Check if too much power is output.
DC APPLICATION
The DC power is exclusively for a 12V battery. Do not use the power for other
than charging.
WARNING:
●
Place the battery in a well ventilated area and keep fire
away. Be careful to avoid sparks. The battery generates
ignitable gases and there is a danger of explosion.
●
The battery electrolyte (diluted sulfuric acid) entering
the eye or attaching on the skin or clothes may cause
loss of sight or injuries. Take sufficient care for the
handling. If it attaches, immediately flush with a large
amount of water and get medical attention.
●
When disconnecting the cable from the battery,
disconnect the cable first. On contrary, connect the
cable first when connecting. If the order is wrong, a
short-circuit may be caused.
1. Remove the cables and tubes from the battery.
2. Measure the specific gravity of the battery electrolyte and determine the
charging time.
● Remove the electrolyte supply caps of the battery and check the
electrolyte level. If the level is low, supply distilled water to the upper limit.
● Measure the specific gravity of the battery electrolyte and determine the
charging time in the table on the right.
The specific gravity of a fully charged electrolyte is 1.26 to 1.28. The
charging time varies according to the type of the battery and discharge
conditions. Check every hour.
3. Connect the charging cable between the DC terminals and battery terminals.
CAUTION:
●
Use the special charging cable (option) for connection
with the battery.
●
Do not make a mistake in the and polarities when
connecting the charging cable. Wrong connection may
cause a short circuit or failure of the generator or battery.
4. Adjust the output selection switch of the generator to 950VA and start the
engine to start charging.
Fig. 32
Fig. 31
Plug
Aim for specific gravity and charging
time
Charging time (Hr)
Specific gravity (20°C)
Battery : Battery capacity
(30Ah 20HR)
(35Ah 20HR)
(47Ah 20HR)
Fig. 30
Pilot lamp
Oil sensor lamp
AC outlet
Plug
Fig. 33
Charging cable
Charging cable
(option)
Part No. KY16010AA
Содержание E10U
Страница 4: ...4 English ...
Страница 125: ...711 Code No C99169791 Printed in Japan Mfg Code KN55091AA ...