English
45
Turning DVD Video Camera/Recorder On and
Off
While holding down the gray button at the right
of power switch, set the switch according to
each recording function:
Power ON status
During playback, set the power switch to “
O
”
or “
N
” when using disc, or set it to “
P
” when
using card.
Turn the switch while holding down the gray
button at the right of switch.
Note
:
•
Once you turn the DVD video camera/recorder on to
let it recognize the disc, you can immediately record
or play back by turning the DVD video camera/
recorder on again. However, if a long time has
elapsed after the disc was inserted, it will take some
time for the DVD video camera/recorder to start
because it must recognize the disc again (see
page 169).
•
It will take some time for the DVD video camera/
recorder to display the Disc Navigation screen after
power is turned on.
•
If you turn the DVD video camera/recorder on, the
ACCESS indicator will light or blink to show that the
DVD video camera/recorder is recognizing the disc or
card: During this time, no operation, such as
recording, can be performed.
After several seconds, the ACCESS indicator will go
out, and operating the DVD video camera/recorder
will be possible.
If the ACCESS indicator does not go out, refer to
“Check 4” on page 169.
•
When the DVD video camera/recorder is turned on,
the self-diagnosis function will work and a message
may appear. In this case, refer to “Trouble Messages”
on page 171 and take corrective action.
•
While the ACCESS/PC or CARD ACCESS indicator is
lit or blinking, do not violently open or close the LCD
monitor.
•
When the ACCESS/PC or CARD ACCESS indicator
is lit or blinking, do not remove the battery or AC
adapter/charger.
Set to “OFF”:
The DVD video camera/
recorder will turn off
Set to “
P
”:
To record still on SD
memory card
Set to “
O
”:
To record movie on DVD-
RAM/DVD-RW/DVD-R
disc
Set to “
N
”:
To record still on DVD-
RAM disc
OFF
OFF
Power switch
ACCESS/PC
indicator
CARD ACCESS indicator
