--- 13 ---
Fig. 8
(d) Install the Shift Arm [19] into the assembly reassembled in step (c).
With the ridge at the Shift Arm [19] facing the Motor [28] side, first install them on the unmarked side of the
assembly reassembled in step (c). Then insert the projections on the Shift Arm [19] into the holes in the
Rear Case [17] and make sure that the projections are fitted into the grooves in the Slide Ring Gear [20]
mounted within the Rear Case [17]. (See Fig. 10.)
(c) Install the Click Spring [5] and the Cap [4] to the assembly reassembled in step (b). (See Fig. 9.)
(i) Insert the ridge and the projections of the Click Spring [5] into the holes of the Cap [4].
(ii) When the Nut [6] is screwed in the Front Case [9] about one and a quarter turns, the three projections of
the Nut [6] and the marking of the Rear Case [17] are positioned as shown in Fig. 9. Mount the Cap [4]
aligning the ridge of the Click Spring [5] with the three projections of the Nut [6].
Recess
Projection
[26]
Projection
Fig. 9
Click Spring [5]
Marking of the
Rear Case [17]
Holes
Ridge
Three projections of the Nut [6]
Cap [4]
Projections
