English
26
OPERATION
1. Mounting and dismounting of the bit.
(1) Mounting the bit.
Loosen the sleeve by turning it toward the left
(in the counterclockwise direction as viewed
from the front) to open the clip on the keyless
chuck. After inserting a driver bit, etc., into
the keyless drill chuck, and tighten the sleeve
by turning it toward the right (in the clockwise
direction as viewed from the front). (See
Fig. 3
).
NOTE
If the sleeve becomes loose during operation, tighten it further.
The tightening force becomes stronger when the sleeve is tightened.
2. Dismounting the bit
Loosen the sleeve by turning it toward the left (in the counterclockwise direction as viewed
from the front), and then take out the bit etc. (See
Fig. 3
)
CAUTION
When mounting a bit into the keyless chuck, tighten
fi
rmly. If the sleeve is not tight,
the bit may slip or fall out, causing injury.
NOTE
Loosening stuck or hard to move sleeves.
Grasp the bit installed in the keyless chuck, in a vise or similar tool.
Set the clutch dial position to “1-11” and turn on the switch. The motor then starts.
Finally, rotate the sleeve to the left, and it will loosen.
3. Con
fi
rm that the battery is mounted correctly.
4. Check the rotational direction.
The bit rotates clockwise (viewed from
the rear side) by pushing the R-side of the
selector button.
The L-side of the selector button is pushed
to turn the bit counterclockwise (See
Fig. 4
).
(The
L
and
R
marks are provided on the
body.)
○
When the trigger switch is depressed, the tool
rotates. When the trigger is released, the tool
stops.
○
The rotational speed of the drill can be controlled by varying the amount that the trigger
switch is pulled. Speed is low when the trigger switch is pulled slightly and increases as the
trigger switch is pulled more.
○
When releasing the trigger of the switch, the brake will be applied for immediate stopping.
Loosen
Sleeve
Tighten
Fig. 3
R
L
Selector button
Trigger switch
L
mark
R
mark
Fig. 4
0000Book_DS10DAL_ChS.indb 26
0000Book_DS10DAL_ChS.indb 26
2015/4/22 13:32:29
2015/4/22 13:32:29
