-7-
Fig. 12 • Inserting the change plate
[119]
[42]
Stepped portion of the Change Plate
[119]
Notch of the Slider
[42]
(6) Mounting the crank cover
• Insert the stepped portions of the Change Plate
[119]
into the notches of the Slider
[42]
.
NOTE: Be careful of the inserting direction. See the figure below.
• Mount the Cylinder O-ring
[117]
to the outer diameter portion on the bottom of the Lever Shaft Holder
[116]
. Set the Change Lever
[112]
to "Ro Hammering" mode position.
• Put the assembly of the Lever Shaft Holder
[116]
and Crank Cover
[111]
on the Crank Case Ass'y
[91]
and fix them with the Hex. Socket Hd. Bolts M5
[110]
.
NOTE: After tightening the Hex. Socket Hd. Bolts M5 [110], check the following:
• The Change Lever [112] rotates smoothly.
• The Retainer Sleeve [28] is kept from rotating when the Change Lever [112] is set to
"Hammering" mode.
• The Retainer Sleeve [28] rotates smoothly when the Change Lever [112] is set to
"Neutral" mode.
