Hitachi CR 24DV, Техническое и сервисное руководство

Страница: 18 / 27

--- 15 ---
8-1-2. Reassembly
Reassembly can be accomplished by following the disassembly procedures in reverse. However, special
attention should be given to the following items.
(1) Reassembly of the blade mounting section (Figs. 8, 9 and 10)
Apply Doubrex 251 grease (Code No. 971042)
to the inner circumference of Holder Sleeve (B)
[4] and the cam groove of the Plunger [14].
Insert the tip of the Plunger [14] into Holder
Sleeve (C) [6], Holder Sleeve (B) [4] and
Holder Sleeve (A) [3] in order. Next, align the
hole of the Plunger [14] with the notches of
Holder Sleeve (A) [3] and Holder Sleeve (B) [4]
as shown in Fig. 9. Insert the Holder Pin [1]
into the hole and push it in. Slide Holder
Sleeve (B) [4] and Holder Sleeve (C) [6]
forward and turn them about 90˚ clockwise
viewing from "A". Insert the two Steel Balls
D4.76 [5] (use the arrow marks shown in Figs.
9 and 10 as the reference). Insert the other
end of the Plunger [14] into the Guide Washer
[7], Dust Washer [8], Spring (A) [9], Washer
(D) [12], Thrust Bearing [11] and Washer (E)
[10] in order. Mount the Retaining Ring (E-
type) for D14 Shaft [13] securely by adjusting
Spring (A) [9]. Be careful of the projections
and depressions on Holder Sleeve (B) [4] and
Holder Sleeve (C) [6] when mounting. After
reassembly, test-mount and remove a saw
blade to check for proper operation.