Problem
After a power failure, thunderstorm, etc. a malfunction
may occur. Example: The receiver does not respond to
the remote control commands.
Solution
Switch off the receiver by using the mains switch, wait
for about 10 seconds and switch the receiver on again.
Regular vertical or diagonal lines are shown on the
screen.
Connect a double shielded aerial cable between the
aerial connector of the receiver and the aerial wall
socket.
The colour purity of the picture tube is poor.
Switch off the TV set by using the mains switch and
allow it cool down for about 15 minutes. When the TV
set is switched on again, automatic degaussing of the
picture tube maintains the colour purity.
Permanent distortion on the screen (on its edges).
Check that the Decoder setting in the Manual tuning
menu is set to OFF.
Move all devices causing strong magnetic fields, e.g.
additional loudspeakers farther away from the TV set.
Switch off the TV set by using the mains switch and
allow it cool down for about 15 minutes. When the TV
set is switched on again, automatic degaussing of the
picture tube maintains the picture format and colour
purity.
When selecting a programme number (not E
programme number), either a programme from a device
connected to the Scart E1 connection is shown, or there
is no picture at all on the screen.
Some programme channels or menus cannot be
selected, or the message "Enter code number to open
lock" appears on the screen.
See instructions in the section "Parental lock". If you
have lost the code number, use the sequence 1-5-9-red
"ZOOM" button on the remote control unit to open the
lock.
32
Before you call a serviceman
Technical data
System
PAL B, G
NTSC 3.58/4.43 via Scart connector
Mains power
210-240 V, 50 Hz
Power consumption
135 W (normal)
Power consumption in stand-by
max. 0,2 W
Picture tube
28"/71 cm, 29"/74 cm
Frequency range
48.25 - 855.25 MHz
Programme memory locations
99
AV memory locations
3
Sound output
2 x 10 W
RMS
/8
Ω
Connections on the front panel
Headphones
32...600
Ω
, 3,5 mm
Audio/Video
Audio in: 0 - 2 V
RMS
/1 k
Ω
Video in: 1 V/75
Ω
Y/C in (SVHS)
Connections on the rear panel
Audio/Video (Scart)
Audio in: 0 - 2 V
RMS
/1 k
Ω
Audio out: 0 - 2 V
RMS
/10 k
Ω
Video in/out: 1 V/75
Ω
RGB in: 0,7 V/75
Ω
(E1)
Y/C in (SVHS) (E2)
Audio out
0 - 2 V
RMS
/10 k
Ω
(RCA)
Ext. loudspeakers
min. 10 W
RMS
/8
Ω
Antenna
75
Ω
, coaxial cable
Specifications are subject to change.
3P58 83041010-GB
