– 19 –
CP-X325W
• Loading the Battery
CAUTION
• Use only the specified batteries with this remote control. Also, do not mix new and old batteries.
This could cause in battery cracking or leakage, which could result in fire or personal injury.
• When loading the batteries, make sure the plus and minus terminals are correctly oriented as
indicated in the Remote control transmitter transmitter. Incorrect orientation could cause battery
cracking or leakage, which could result in personal injury or pollution of the surrounding environment.
• When you dispose the battery, you obey the law in the relative area or country.
• Keep the battery away from children and pets.
• When not to be used for an extended period, remove the batteries from the Remote control transmitter.
• Lamp
HIGH VOLTAGE
HIGH TEMPERATURE
HIGH PRESSURE
Contact your dealer before replacing the lamp.
(Option lamp: DT00331)
Before replacing the lamp, switch power OFF, remove the power cord from the power outlet, and wait
approximately 45 minutes until the lamp has cooled. The lamp may explode if handled at high temperatures.
• For disposal of used lamp, treat according to the instruction of community authorities.
• Since the lamp is made of glass, do not apply shock to it and do not scratch it.
• Also, do not use old lamp. This could also cause explosion of the lamp.
• If it is probable that the lamp has exploded (explosive sound is heard),
disconnect the power plug from the power outlet and ask your dealer to
replace lamp.
The lamp is covered by front glass , but, in rare cases, the reflector and
the inside of the projector may be damaged by scattered broken pieces
of glass, and broken pieces could cause injury when being handled.
• Do not use the projector with the lamp cover removed.
Reflector
Front
glass
Lamp life
Projector lamps have a finite life. The image will become darker, and hues will become weaker, after a lamp has
been used for a long period of time.
Replace the lamp if the LAMP indicator is red, or the CHANGE THE LAMP message (see P.20 Table 8) appears
when the projector is switched ON.
NOTE: The LAMP is also red when the lamp unit reaches high temperature. Before replacing the lamp, switch
power OFF, wait approximately 20 minutes, and switch power ON again. If the LAMP indicator is still red,
replace the lamp.
Install the AA batteries into the remote control.
1. Remove the battery cover.
Push the knob while lifting up the battery cover.
2. Loading the batteries.
Make sure the plus and minus poles are correctly
oriented.
3. Close the battery cover.
1
2
NOTE: Replace the batteries when remote control operation becomes difficult.
Lamp
