Hitachi CP-X205W(C14-20N), Руководство по обслуживанию

Страница: 39 / 96

39
CP-X205W (C14-20N) / CP-X305W (C14-25N)
Wiring diagram 3
CNGD1
CNLAP
CNGD1
CNPFC
CNPFC
TSW
TSW
FEB2
CNPW
CNPW CNPW
FEB2
Ballast power unit
Ballast sheet
Ballast holder
Ballast holder
Circuit power unit
Circuit power unit
Ballast holder
Make sure not to release the CNLAP from ballast holder hook.
Do not incline the board.
Style the CNLAP lead on ballast sheet.
<Wiring of the CNLAP>
Ballast power unit
Arrow A
Assemble the ballast holder touching the CNPW to the arrow A side wall of the ballast holder. You can easily draw out the CNPW from ballast holder hole.
Do not make the excessive length in the power unit. Do not pull the CNGD1 and the TSW strongly.
2.Assembling of the circuit power unit and ballast power unit.
Assembling of the power unit block
The assembly order of the power block
Assemble the circuit power unit and ballast power unit (Ballast holder) by the following procedures. Refer the wiring of the power unit block (Next page) to style the cables, after you assembled the power unit block.
(1)
Attach the ballast holder to the circuit power unit drawing out the CNPW. Assemble the ballast holder and the circuit power unit touching the CNPW to the arrow A side wall of the ballast holder. You can easily draw out the CNPW.
(2) Draw out the CNPW from the ballast holder hole, then style the CNGD1 and the TSW.
Do not make the excessive length in the power unit. Do not pull the CNGD1 and the TSW strongly, otherwise connector might be released.
(3) Style the igniter lead (CNLAP) on the ballast sheet.
Make sure not to release the CNLAP from ballast holder hook, then attach the ballast holder with screws.
1.Connection of the circuit power unit and the ballast power unit, Preparation for assembling.
(1) Connect the CNPFC to the circuit power unit. (2) Pass the CNGD1 and the TSW through the ballast holder hole.