Hitachi CP-X1200 Series, Руководство пользователя

Страница: 48 / 78

33
Multifunctional Settings (continued)
Multifunctional Settings (continued)
OPTION Menu
With the OPTION menu, the items shown in the table below can be
performed. Perform each operation in accordance with the
instructions in the table below.
: SELECT
MENU
MAIN
PICTURE-1
PICTURE-2
INPUT
AUTO
SCREEN
OPTION
NETWORK
VOLUME
SPEAKER
IR REMOTE
IR REMOTE ID
LAMP TIME
FILTER TIME
SERVICE
RESET
16
TURN ON
ALL
1234 h
4321 h
Item Description
VOLUME
Adjust the volume using the / buttons. :
High Low
SPEAKER
Select the TURN ON or the TURN OFF using the / buttons. :
TURN ON TURN OFF
When the TURN ON is selected, the built-in speaker works.
IR REMOTE
Select a remote sensor using the / button (1), then switch
it using the ENTER button (2). :
(1) FRONT TOP REAR (2) (Off) (On)
memo A sensor cannot be turned off when the other two are off.
Always at least one sensor is on.
IR REMOTE ID
Select a number as an ID number for remote control using the / buttons. :
ALL 1 2 3
The projector is controlled by the remote control whose ID CHANGE switch is
set into the position of the same number as this number. When the ALL is
selected, the projector is controlled by a remote control irrespective of the
position of the ID CHANGE switch.
memo Please refer to the section “Using The Remote ID Feature”.
LAMP TIME
Pressing the RESET button for about 3 seconds displays the LAMP TIME menu.
Select the RESET using
button to reset the timer. :
RESET CANCEL
Selecting the RESET resets the count of the lamp timer to 0.
memo Perform this function only when you have replaced the lamp. The lamp
timer counts the used time of the current lamp, to display the messages about
the lamp. Incorrect performing causes incorrect operation of the messages.
memo About replacing the lamp, please refer to the section” Lamp”.
FILTER TIME
Pressing the RESET button for about 3 seconds displays the FILTER TIME
menu.
Select the RESET using
button to reset the timer. :
RESET CANCEL
Selecting the RESET resets the count of the lamp timer to 0.
memo Perform this function only when you have cleaned or replaced the air
filter. The filter timer counts the used time of the air filter after cleaning or
replacement, to display the messages about the air filter. Incorrect performing
causes incorrect operation of the messages.
memo About caring for the air filter, please refer to the section “Air Filter”.
OPTION
IR REMOTE
FRONT
TOP
REAR
ENT
(This table is continued to the following page.)
01CP-X1200-ENG-OG-三校 03.12.5 1:10 PM ページ33