Hitachi CP-SX1350 P5SX+, Руководство по обслуживанию

Страница: 33 / 78

33
CP-SX1350(P5SX+)
#6607
Fan for the red colored panel
Attach with the optical unit assembly
.
Attach with the optical unit assembly
.
Attach with the optical unit assembly
.
A83
Left speaker
CNRM
Signal board
Fan for the blue colored panel
CNME
#6606
After connecting the CNME cable to the EY01 connectors for the dust sensor board, attach it to the optical unit.
#6604
Fan for the green colored panel
CNLS
CNLS
Make sure to not tangle the cables when mounting the optical unit.
2. Wiring of the optical unit when it is mounted to the bottom case
Connect the CNRM cables to the ER01 remote control's connectors.
* Attach the remote control board, the clasps and cover as per the assembly diagram.
TA
P
2
Pull the CNLS cables to the rear so that they do not get caught in the gear cogs, after using the T
AP2 to clasp them underneath
the lens.
Connect the CNLS cables to the connectors that are besides the lens. Pass them underneath the lens as depicted in the diagram at right. They need to be configured so that they do not catch on the lens or the motor's gears. Connect the cable end that is closest to its binding T
apes to the
connector beside the lens.
Do not stress the flexible cable for the lens when wiring the CNLS cable.
TA
P
2
FRONT
VIEW
Lens
#680
Lamp fan
Protruding part
Cover the protruding portion of the clasp with tape. (As per the assembly diagram.)
Pass the CNLC cable underneath the protruding part of the clasp as depicted in the diagram to prevent the switch lever cable from becoming enclosed.
CNLS
Clasp underneath the lens
Install the switchboard in the clasp in the optical unit assembly
.
The optical unit may be installed with CNLC cable connected to the E941 connector
.
Lever
Attach with the optical unit assembly
.
Wiring diagram 3
Attach T
A
P
2, after configuring the cable in the
approximate center of the clasp underneath the lens. (So that the gears of the motor do not catch, make sure that they do not get caught on the base of the lens when the lens is shifted downward.)
Make sure that the CNLS connector is connected firmly and straightly to the connector beside the lens, after attaching T
A
P2.
CNLC