Hitachi CP-SX1350 P5SX+, Руководство по обслуживанию

Страница: 31 / 78

31
CP-SX1350(P5SX+)
7. Wiring diagram
CNPWR
1. Wiring of the electrical board block (1) Wiring of the electrical board (for assembling the electrical board sub assembly).
Pass the three kinds of cables through the notch in the power board holder
,
and take up any slack. (The resulting slack may come into contact with the primary side of the power board.)
TSW
CNPW1
CNPW2
Connect the CNPW1, CNPW2 and TSW cables to the respective connectors for the CN102, CN103, and CN104 circuit power boards, and verify that they are properly connected. Be careful not to pull on the cables too much when reducing slack so as not to compromise the connectors.
CNPW1 CNPW2
TSW
CN102
CN103 CN104
Be careful not to lift the connectors in the three spots as depicted in the illustration at left. The connections have become compromised.
Example of compromised connections
(2) Wiring of the ballast board (for assembling the ballast board sub assembly).
Lamp leads
CNBAR
Pass the CNBAR cable through the notch in the ballast holder
.
Connect the CNBAR cable to the ballast board's CN2 connectors, and make sure that they are well connected.
CN101
CN1
CN2
CN104
CN103
CN102
Connect the CNPWR cable to the circuit power board's CN101 connector
, make
sure that the connector lock is snug. Attach FEB1 to the CNPWR cable. SK binder does not need to be used. Get close to the circuit power board's CN101 connector
.
FEB1
Wiring diagram 1