Hitachi CM2096ME, Руководство пользователя

Страница: 8 / 20

Install the monitor on a horizontal base.
DO NOT expose this monitor to rain or moisture to prevent electric shock or fire hazard.
This unit is designed to be used in an office or business environment.
DO the unit to vibrations, dust, or corrosive gases.
DO NOT cover this monitor or place anything against any sides (not only top, right and
left side but also rear and bottom side) of unit. Ventilation holes are provided at all sides
of the back cover to prevent the temperature from rising.
AVOID placing the unit in direct sunshine or near a heating appliance.
DO NOT place a magnet, loudspeaker system, floppy disk drive, printer, or anything which
will generate magnetism near the unit. A magnetic field may cause blurred colors or
distortion of the displayed pattern.
Make sure the Power Switch is “OFF”.
Connect a power cord to the “AC Inlet” of the monitor.
Connect the plug of the power cord to a receptacle of the correct voltage.
q
In USA/Canada, use a UL or CERTIFIED power cord set meeting
the following specifications.
Rating: min. 7A Length: max. 3.1 m Type: SVT or SJT
Plug type: NEMA 5-l Parallel blade, Grounding type, 15A
Failure to do so may cause fire or electric shock hazard.
In Europe, a proper European standard approved power cord is to be used with this
monitor. For a rated current up to 6 A, a type not lighter than
3G 0.75
or 3G 0.75 shall be used.
The accessory power cord shall be used if provided.