-5-
Ɣ
Attaching the blade attachment, cam rod holder and cam rod
facing the Gear
[35]
on the blade.
(6) Apply grease (Shell Alvania Grease RL3) to the tooth surface on the Gear
[35]
, sliding portion on the
Cam Rod
[34]
, and the cam. Place the Washer
[33]
on top of the Ball Bearing 608DDC2PS2L
[32]
,
and insert the shaft of the Gear
[35]
into the Ball Bearing 608DDC2PS2L
[32]
. Ensure the Cam Rod
[34]
and the Gear
[35]
are interlocked.
(7) Apply grease (Shell Alvania Grease RL3) to both sides of the Cam Rod
[34]
(bottom cover), inner
diameter of the cam alignment hole, and interlocking hole on the blade pin. Then press them onto the
blade pin and the Gear
[35]
cam. Place the Washer
[33]
on the shaft of the Gear
[35]
. Ensure the
Cam Rod
[34]
is attached with the shear droop surface facing the Gear
[35]
(on the blade).
(8) Slide the Cam Rod Holder
[39]
toward the Gear
[35]
so that it sandwiches the two Cam Rods
[34]
and
the blades (upper and lower).
Washer
[33]
Cam Rod Holder
[39]
First Gear
[37]
Cam Rod
[34]
Sandwich the two Cam
Rods
[34]
and the upper
and lower blades inside
the Cam Rod Holder
[39]
.