Hitachi CG 25SC, Руководство по обслуживанию

Страница: 5 / 19

-4-
Fig. 8
Reverse the disassembly procedure to reassemble the Model CG 25SC. However, pay particular attention
to the following.
1. Notices on reassembly
(1) Press-fit the Wire Roll Support [41] to the Motor [39] until the
Wire Roll Support [41] contacts the ball bearing of the Motor
[39] .
NOTE: Do not press-fit with excessive force. Otherwise,
the Wire Roll Support [41] may be broken.
After press-fitting, put the Cap [45] on the M5 Nut [44] and
tighten it to the shaft of the Motor [39].
NOTE: Do not press-fit with excessive force. Otherwise,
the Cap [45] may fall off.
NOTE: The wire roll support of the Model CG 25SC is
similar to that of the Model CG 30SC but they are
not interchangeable (13.5-mm portion is slightly
different in shape.) Do not mismount.
NOTE: Replace the Wire Roll Support [41] with new one
without fail when replacing the Motor [39].
(2) Mount the Lock Off Button [12] and Spring (B) [14] into Handle (L) [13] , and then put Handle (L) [13]
and Handle (R) [5] together aligning the position of Spring (B) [14] .
NOTE: When putting Handle (R) [5] and Handle (L) [13] together, completely fit the internal
wires into the grooves of the handle ribs so that the internal wires are not pinched by
the handle bodies.
NOTE: The position of the Lock Off Button [12] is predetermined. Fit the protrusion of the Lock
Off Button [12] in the recessed portion of Handle (L) [13].
[13]
[12]
[14]
Fig. 7
[39]
[41]
[44]
[45]
13.5 mm
[11]
[10]
[2]
[1]
[3]
[8]
[9]
[15]
[24]
[10]
[11]
Reassembly of the Model CG 25SC
[7]