Hitachi CG 22 EAD (SL), Инструкции по безопасности и руководство пользователя

Страница: 9 / 64

9
English
Attach the protection tube to the drive shaft or handle
using cord clamps (8). (Fig. 5)
8
Fig. 5
NOTE
If the protection tube is set apart from the handle
or pipe, it will be caught by something during
operation and it may cause serious injury. Do not
set the protection tube apart from the handle or
pipe.
Throttle wire / stop cord
Press the upper tab (9) and open the air cleaner
cover. (Fig. 6)
9
Fig. 6
Connect stop cords. (Fig. 7)
Fig. 7
If the throttle outer end (10) is threaded on your unit,
screw it and the earth terminal (11) (if so equipped)
into the cable adjuster stay (12) all the way, and then
tighten this cable end using the adjuster nut (13)
against the cable adjuster stay (12).
Connect throttle wire end (14) to carburetor (15)
and install swivel cap (16) (if so equipped) where is
included in tool bag, onto swivel (15) (Fig. 8).
Some models may come with the parts installed.
11
12
10
13
14
15
16
Fig. 8
Installation of blade guard (Fig. 9, 10, 10-1, 11)
WARNING
●
Do not start or operate unit unless each
guard is properly assembled to unit.
●
lf unit is operated without a sharp line
limiters, the line will become too long, the
engine will overheat, and engine damage
may occur.
●
Check sharp line limiters surely cut nylon
line when operating.
Fig. 9
Fig. 10 Fig. 10-1
000Book̲CG22EAS̲US.indb 9 000Book̲CG22EAS̲US.indb 9 2012/07/09 7:44:38 2012/07/09 7:44:38