--- 2 ---
4-1. Selling Point Descriptions
(1) Parallel adjustment system
The parallelism can be easily fine-adjusted by using the parallel adjustment system. The parallelism may be
slightly shifted when the cutting depth is adjusted. If the parallelism is shifted, adjust it according to the
following procedure.
(a) Loosen the locking screw of the saw cover hinge (Fig. 1).
(b) Draw the protective cover in the saw cover.
(c) Hold a piece of wood to the rear of the base and put a mark on the piece of wood at the side of the base
(Fig. 2).
(d) Move the marked piece of wood to the front of the base and turn the parallel adjustment screw until the
mark aligns with the side of the base (Fig. 3).
(e) After adjustment, tighten the locking screw securely.
(2) Accurate and sturdy aluminum die-cast base
Thanks to the sturdy aluminum die-cast base, the Models C 6MFA/C 7MFA can cut workpieces accurately and
the cut surfaces of the workpieces are smooth.
(3) High performance 40-tooth tungsten carbide tipped (TCT) saw blade as standard
High performance TCT saw blade (40 teeth) is provided as standard instead of the conventional combination
blade. The Models C 6MFA and C 7MFA provide greater maximum cutting depth than the conventional
models by using a 165 mm dia. TCT saw blade and a 190 mm dia. TCT saw blade respectively.
(4) Double-insulated construction
Grounding is not required thanks to the double-insulated construction.
Fig. 1
Fig. 2
Fig. 3
Saw cover
Mark
Parallel
adjustment
screw
Lower guard
Mark
Содержание C 6MFA
Страница 24: ......