Hitachi BL 26200, Инструкция по эксплуатации

Страница: 4 / 156

4
English
CAUTION ON LITHIUM-ION BATTERY
The Back Pack Power Supply is equipped with a protection
function to halt output in order to extend the life expectancy
of the built-in lithium-ion battery.
There are cases in which operations will be halted even
when the power switch to the Back Pack Power Supply is
on in the following three cases, but this is caused by the
protection function and is not a malfunction.
1. Output is halted when the remaining battery capacity is
low (drops to a battery voltage of 27.5 V).
In this event, recharge the battery immediately.
2. There are cases in which output is halted if an excessive
load is applied to the Back Pack Power Supply. In this
event, switch o ff the power and resolve the problem of
the excessive load.
3. There are cases in which output is halted if the Back
Pack Power Supply overheats. In this event, cease
use and place in a well-ventilated location away from
direct sunlight until it has cooled down su ffi ciently.
Operations may be resumed after it has cooled down.
Also observe the following precautions.
WARNING
Observe the following without fail to prevent battery
leakages, overheating and the outbreak of smoke and
fi re before they happen.
1. Make sure shavings and dust do not accumulate on the
Back Pack Power Supply.
• Make sure shavings to not fall onto the Back Pack
Power Supply during operations.
• Do not leave the Back Pack Power Supply
in locations in which shavings or dust may
accumulate.
• Do not store the Back Pack Power Supply
in locations in which shavings or dust may
accumulate, and separate it from metal objects
(screws, nails, etc.)
2. Do not drive nails into the Back Pack Power Supply, hit
it with hammers, step on it, throw it or otherwise subject
it to powerful impact.
3. Do not use Back Pack Power Supplies that are severely
damaged or malformed.
4. Do not use the Back Pack Power Supply with the [+]
and [–] poles reversed.
5. Do not plug the Back Pack Power Supply directly into
power sockets or cigarette lighter sockets in vehicles.
6. Do not use the Back Pack Power Supply with any
equipment other than that speci fi ed.
7. In the event of the recharger not being fully recharged
despite the recommended recharging time being
greatly exceeded, cease use immediately.
8. Do not insert the Back Pack Power Supply in microwave
ovens, high-pressure containers or otherwise subject it
to excessive heat or pressure.
9. Do not short-circuit the terminals on the Back Pack
Power Supply.
Storing it in bags together with nails, etc., may result in
short-circuits, leading to the outbreak of smoke or fi re,
or damage, etc.
10. In the event of the Back Pack Power Supply leaking
liquid or emitting foul odors, cease use immediately
and place it well away from naked fl ames.
11. Do not use the Back Pack Power Supply in locations
subject to powerful levels of static electricity.
12. In the event of foul odors, overheating, discoloring,
malformation or other abnormalities not previous
noticed being apparent when the Back Pack Power
Supply is in use, being recharged or being stored,
immediately disconnect the equipment or recharger
connected to it and do not use it again.
13. Do not place the Back Pack Power Supply in regular
trash or fi re.
Failure to observe this may result in it bursting or
releasing toxic substances.
CAUTION
1. In the event of liquid leaking from the Back Pack Power
Supply entering the eye, rinse it thoroughly with clean
water without rubbing it, and then contact your doctor
immediately.
Leaving it unattended may result in damage to the eye.
2. In the event of liquid leaking from the Back Pack Power
Supply coming into contact with skin or clothes, rinse it
thoroughly with clean water.
Leaving it unattended may result in skin irritation.
3. In the event of rust, foul odors, overheating or other
abnormalities being apparent when using the Back
Pack Power Supply for the fi rst time after purchase,
contact your dealer or Hitachi Authorized Service
Center without using it.
4. Store the Back Pack Power Supply in a location out of
reach of children.
5. Use the Back Pack Power Supply in accordance with
the displayed speci fi cations.
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
BL36200: Back Pack Power Supply
Read all safety warnings and all instructions.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2002/96/
EC on waste electrical and electronic
equipment and its implementation in
accordance with national law, electric tools
that have reached the end of their life must
be collected separately and returned to an
environmentally compatible recycling facility.
Switching ON
Switching OFF
Arm band
Knob bolt
M5 screw
Main switch
Power switch
Warning lamp
Remaining battery indicator switch
USB (A type) output terminal
000Book̲BL36200.indb 4 000Book̲BL36200.indb 4 2014/09/10 10:14:52 2014/09/10 10:14:52