Hitachi 50PD9800TA, Руководство по обслуживанию

Страница: 32 / 88

32
50PD9800TA (FW1)
8. Self-Diagnosis Function
This chassis has 2 modes of self-diagnosis function.
(1) PDP panel check mode: It indicates the one latest record of the PDP panel failure with blinking of the
power indication light (LED).
(2) Signal circuit check mode: It indicates the check result on some points of the signal circuit and the history
of them with On-Screen Display (OSD).
PDP panel self-diagnosis function
This function is for a PDP panel failure with no picture.
To enter to this Self-Diagnosis mode, follow the next steps:
Preparation:
1) The Power Cord should be connected to AC line and the Main Power switch should be turned on.
2) Turn the power off by the SUB-POWER( ) button by the control panel or by the remote control.
Procedure:
1) Press the SUB-POWER( ) button and button on the bottom of the monitor at the same time, and keep
it for more than 5 seconds after the power turned on.
2) It generates red blinking series of the power indicator light.
3) Any operation would cancel the Self -Diagnosis mode.
4) The next table shows the PDP PWB in which failure most probably would be allocated according to the
number of blinks.
Number of red blinks Presumed failing PWB
of power indication light of PDP panel
1 Logic
2 X-SUS
3 Y-SUS, SDM SDM: Scan Driver Module
4 X-SUS, Y-SUS, SDM, PSU PSU: Power Supply Unit
5 ABUS, ADM, PSU ADM: Address Driver Module
6 ADM temperature
7 ADM temperature
8 All of above-mentioned
PWB’s
Note) SDM is permanently contacted to glass part
[Blinking condition of power indication light]
Ex. 2 blinks
1 sec 1 sec 2 sec OFF Repeat